5
6
GA
M
E
CH
AT
ON
M
IC
M
UT
E
GA
M
E
CH
AT
ON
M
IC
M
UT
E
PS3
™
Setup
Console A/V cable or
HDMI Cable
USB Cable
(included)
Optical Cable
(included)
PS3
1.
Connect the digital optical cable (included) from the digital output on your PS3 to the digital input on the DSS2.
(
NOTE:
Remove the protective caps from each end of the optical cable before inserting into the sockets.)
2.
Connect the DSS2 USB power cable from the power socket on the rear of the DSS2 to a free USB port on your PS3.
3.
Slide the DSS2 power switch to the ON position. The Power LED on the DSS2 will turn ON.
4.
Insert the green 3.5mm connector from the headset to the Headphone Output Jack on the front of the DSS2. Then insert the USB
connector from the headset to the USB Output on the DSS2.
5.
Adjust the Volume Control knob to adjust the overall volume level of the Headset Output.
1
2
3
4
5
OR
Configure PS3 System Settings
Audio Output Settings
12/14 12:15 PM
0
On
Sets to output audio through multiple connector
s
simultaneously. Audio output to connectors that a
re
not selected in [Audio Output Settings] is downscale
d
to 2 Ch.
1.
Settings > Sound Settings > Audio Output Settings >
Optical Digital > Dolby Digital 5.1 Ch.
3.
Settings > Accessory Settings > Audio Device Settings >
Input/Output Device >
Turtle Beach P11
.
4.
Adjust microphone level.
2.
Settings > Sound Settings > Audio Multi-Output.
Audio Device Settings
Microphone Level 3
Output Device Turtle Beach P11
Turtle Beach P11
Back
Options
X Enter
OK