Turnils FA 22, Руководство по установке

Страница: 12 / 16

INSTALLATION - OPERATION - CLEANING — FA SERIES FOLDING ARM AWNING
12
ADJUSTMENT OF PROJECTION ANGLE (FA58 SERIES)
© Hunter Douglas 1-2017 4
Terrace awning
FA50
Installation - Operation - Cleaning
2 Adjustment of projection angle - Standard
The awning’s projection angle is ad-
justed with the stop screw and the
nuts located in the arm holder.
Crank out/roll out the awning. Ad-
just one arm at a time. Loosen the
arm bracket screws (1) one to two
turns.
When adjusting, lift the arm so that
the stop screw (2) is not stressed.
(NOTE! There may be a bang when
the arm is lifted and the conical
washer loosens.)
Adjust the stop screw (2) so that the
arm has the desired height position.
The recommended minimum incli-
nation is 10 degrees.
- If the stop screw is screwed in
then the arm will be raised. - If the
stop screw is screwed out then the
arm will be lowered.
Tighten the nuts (1) in the arm
bracket slightly. The other arms are
adjusted in the same way.
A ground clearance of 2.0 - 2.2 met-
res at the front edge of the awning
is recommended.
Roll in the awning.
Tighten the nuts (1) more (min
50Nm)
a
1
2
Roll out and in the awning several
times, check that it looks right and
functions correctly.
b
A. The awning’s projection angle is adjusted with the stop screw and
the nuts located in the arm holder.
Crank out/roll out the awning. Adjust one arm at a time. Loosen
the arm bracket screws (1) one to two turns.
!
Do not loosen the arm bracket screw more than 3 complete
turns.
When adjusting, lift the arm so that the stop screw (2) is not
stressed.
(NOTE! There may be a bang when the arm is lifted and the
conical washer loosens.)
Adjust the stop screw (2) so that the arm has the desired height
position.
The recommended minimum inclination is 10 degrees.
- If the stop screw is screwed in then the arm will be raised.
- If the stop screw is screwed out then the arm will be lowered.
Tighten the nuts (1) in the arm bracket slightly. The other arms
are adjusted in the same way.
A ground clearance of 2.0 - 2.2 metres at the front edge of the
awning is recommended.
Roll in the awning.
Tighten the nuts (1) more (min 50Nm)
B. Roll out and in the awning several times, check that it looks right
and functions correctly.
ADJUSTMENT OF FRONT PROFILE (FA58 SERIES)
To receive the correct postion of the front profile, the front profile is adjusted as follows:
Roll out the awning until the fabric slackens. Mark position of bracket to ensure you maintain the bracket
position sidewise.
Unscrew the two bottom nuts on the adjustment bracket, holding the front profile.
NOTE! Do not remove the nuts completely.
Move the front profile up or down until receiving the correct position when rolled in.
Fasten the screws.
© Hunter Douglas 1-2017 5
Terrace awning
FA50
Installation - Operation - Cleaning
To receive the correct postion of the front profile, the front profile is adjusted as fol-
lows:
Roll out the awning until the fabric slackens. Mark position of bracket to ensure you
maintain the bracket position sidewise.
Unscrew the two bottom nuts on the adjustment bracket, holding the front profile.
NOTE! Do not remove the nuts completely.
Move the front profile up or down until receiving the correct position when rolled in.
Fasten the screws.
3 Adjustment of front profile FA58