Hextronik AIRplane [6-12]ESC Manual [ Model 2 ] Page 1 7/21/2014
Dear customer,
Thanks for purchase of our Brushless Motor Controller.
Please read and pay carefully attention to the following instructions before you start to work with your motor and
controller.
Wires Connection:
The speed controller can be connected to the motor by soldering directly or with high quality connectors.
Always use new connectors, which should be soldered carefully to the cables and insulated with heat shrink tube. The maximum
length of the battery pack wires shall be within 6 inches.
Solder controller to the motor wires.
Solder appropriate connectors to the battery wires.
Insulate all solder connectors with heat shrink tubes.
Plug the “JR” connector into the receiver throttle channel.
Controller Red and Black wires connects to battery pack Red and Black wires respectively.
Installing the Controller:
Install the controller in the model so that it is free from vibration and shock, using Velcro or double sided foam tape. Make sure
there is sufficient cooling for the motor and controller by ducting air through cooling holes from outside airflow.
Failure to do so, will be cause motor or controller damaged.
Normal start up:
Switch on transmitter and check throttle settings are
+/-100%
(for computer radio).
For Futaba Radio programs use the “Servo Reverse” function on the throttle channel.
Pulls throttle stick in down or brake position;
Transmitter switches “On”,
Connects battery pack to the controller
Receiver switches “On” (BEC switch on).
You will hear one beep for
Brake
on
or two tones for
Brake off.
The position of full throttle will be calibrated automatically.
You motor now is ready to run.
WARNING
:
Always connect the motor battery pack just before flight and disconnects it immediately after landing.
Once the motor battery pack is connected, handle the model with extremely care!
Ensure that you are well clear of the propeller at all times.
Rotating propeller is extremely dangerous!
Even when the receiver (BEC) switch is “OFF”, but please remember the motor battery pack may still be
connected. Handle the model with extremely cares and stay clear of the propeller!
Factory default settings
Brake
:
Off
Battery Type
:
Lipo 10S
Cut-Off Voltage
:
3.2V
Rotation Reverse
:
Normal
Acceleration
:
High
Timing
:
Automatic
Under Voltage
:
Reduce Power
