-
11
-
6.2 Charging of Lithium Battery
INC
INC
DEC
DEC
-
-
+
+
Start
Enter
Batt type
Stop
Start
Enter
Charged
capacity
Number
of
cells
Charging
time
Charging
current
Battery
voltage
The left side of the first line shows the type of battery you
choose. The value on the left of the second line of the
charger is current user set. After setting the current and
voltage, press
Start/Enter
key for more than 3 seconds to
start the process.(charge current: 0.1-10.0A, voltage: 3.7-
22.2V).
This displays the number of cells you set up and the
processor detects. R shows the number of cells detected by
the charger and S is the number of cells set by you at the
previous screen. If both numbers are identical you can start
charging by press
Start/Enter
button. If not, press
Batt
Type/Stop
button to go back to previous screen to carefully
check the number of cells of the battery pack before going
ahead.
This screen shows the real-time status during charge
process. Press
Batt Type/Stop
key once to stop the charge
process.
This charging mode is for charging Li-Po/Ion/Fe battery without balance lead.
Note:
We recommends charging lithium batteries with a balance lead in the
balance
mode
only.
'> 3 seconds '
6.3 'FAST' charging of Lithium battery
The charging current is getting smaller as the process goes to the near end term of
Lithium battery charging. To finish charging process earlier, this program eliminate certain
term of CV process. Actually, the charging current will goes to 1/5 from the initial value to
end the process while the normal charging goes to 1/10 during CV term. The charging
capacity may be a bit smaller than normal charging but the process time will be reduced.
INC
INC
DEC
DEC
-
-
+
+
The value on the left side of the second lines sets the
charge current. The value on the right side of the second
lines sets the battery pack's voltage. After setting current
and voltage, press
Star/Enter
for more than 3 seconds to
start the process.
Start
Enter
Batt type
Stop
'> 3 seconds
'
6. Lithium battery(LiPo/Lilo/LiFe)program
