Turfmech Buffalo 20, Руководство оператора и каталог запасных частей

Страница: 15 / 40

15
7.5 Grease points
8 Grease points in total
(Remove covers to access grease points)
A) 2 cylinder bearings (1 pump every 1-2 weeks)
B) 2 rear roller bearings (1 pump every month)
C) 3 drive shaft bearings (1 pump every 1-2 weeks)
D) 1 idler pulley bearing (1 pump every 1-2 weeks)
Recommended best practice is to grease little and often
7.6 Bottom blade grinding angles
The cutting performance of the Buffalo 34 is highly dependent on the condition of
both the cylinder and bottom blade. Poorly maintained parts will lead to a poor quality
of cut.
Newly fitted bottom blades will need to be ground when bolted to the blade carrier to
ensure a perfectly flat cutting edge.
It is advisable that grinding/reconditioning is carried out by an authorised Allett dealer
to the angles shown below.
7.7 Inspection of safety critical components
The below parts are critical to the safe operation of your lawnmower, before each use
check that:
When the park brake is engaged the mower can not move.
The guards, deflectors and the grass box are in good condition and secured in place
The On/off engine switch stops the mower in case of an emergency
When the bail bars are released the cylinder and land roll drive stop immediately
C
B
D
A