15
85397-85398 Rev F
Grease Fittings:
Lube after every 20 Hours of Operation. Two
(2) fittings, one located on each transport wheel hub.
Chassis:
Lightly lubricate all pivot points with light machine oil.
Chains, Sprockets And Pivot Points:
All bearings in the drive
train require no lubrication. Periodic inspection should be done
to insure that any worn bearings are detected and replaced.
Lubricate and protect chain from rust and moisture with a very
light coating of machine oil. Lubricate all pivot points with light
machine oil.
Transaxle:
The transaxle is a sealed unit that requires no further lubrication. Periodic inspection should
be done to insure that any leaking seals or worn bearings are detected and replaced.
ENGINE:
CHECK OIL LEVELS DAILY.
Follow the engine manufacturer’s manual for
intervals of oil change, proper oil types, and fill levels for the engine. Check oil with
engine sitting level.
TO AVOID SERIOUS INJURY, Never Perform Any Service or Adjustment Procedures With
the Engine Operating.
All Of The Following Lubrication, Service, or Adjustment Procedures Involve Or Are Near
Rotating and Moving Parts.
Use Caution When Working Near the Tine Reel Assembly. Tines Are Sharp and Can Easily
Cut Hands and Feet. Wear the appropriate safety gear.
Use the Transport Locking Pin To Secure The Tine Wheels In A Lowered Position and to
Avoid Accidental Dropping of the Tine Wheels.
Service and Adjustments
SV85384-01
SERVICE
SV85397-01RevF
Lubrication
CLEANING AND HARDWARE INSPECTION
The Aerator operates with vibration. Check
and retighten nuts and screws frequently to
ensure safe operation.
Keep the Aerator free of any buildup of dirt,
cores or debris. Low pressure wash only.
DO
NOT HIGH PRESSURE WASH
. High pressure
washing can force water into the sealed
bearings washing away the lubrication.
ACCESS TO TINES REELS AND TINES
Remove the weight tray to gain access to the
tine reels and to the tines.
REMOVABLE
WEIGHT TRAY
SV85397-03RevF
WARNING
PULL TO UNLOCK DRIVE WHEELS
NEUTRAL
CHECK OIL WITH ENGINE
SITTING LEVEL
