Maintenance
Lubricate Grease Fittings
Service Interval: Every 100 hours—Grease
caster pivots (2x).
Every 100 hours—Grease
idler pivot.
Note:
See chart for service intervals.
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Lubricate fittings with NLGI grade #2
multi-purpose gun grease.
Refer to the maintenance chart for fitting
locations and lubrication schedule.
Lubrication Chart
Fitting
Locations
Initial
Pumps
Number of
Places
Service
Interval
1. Front Caster
Pivots
*0
2
Yearly
2. Idler Pivot
1
1
Yearly
Check Condition of Belt
Service Interval: Every 40 hours
1.
Stop engine, wait for all moving parts to stop, and
remove key. Engage parking brake.
2.
Check the belt condition and tension.
Check Spark Plugs
Service Interval: Every 100 hours
Remove spark plugs, check condition and reset gaps,
or replace with new plugs. See Engine Owner's
Manual.
Wheel Mount Screw Torque
Specification
Service Interval: After the first 100 hours
Every 500 hours thereafter
Torque the lug nuts on the wheel hub to 95 ft-lb (129
N-m).
Check Alternator
Service Interval: As required
20 Amp Regulated Alternator
The 20 amp regulated alternator system provides
AC current through two output leads to the
regulator-rectifier. The regulator-rectifier converts
the AC current to DC, and regulates current to the
battery. The charging rate will vary with engine RPM
and temperature.
1.
Stator assembly (1) (Figure 39)
2.
Two YELLOW leads (2) from Stator.
3.
RED DC output lead (3) from connector.
4.
Connector (4)
5.
Two YELLOW AC input leads (5)
6.
Regulator-rectifier (6)
7.
RED DC output lead (7) to connector
Note:
Stator (1), regulator-rectifier (6) and fly-wheel
are NOT INTERCHANGEABLE with any other
charging system.
g289588
Figure 39
Output Test
51
