SUPRA JZA80 TWIN TURBO BLOW-OFF VALVE ADAPTOR INSTRUCTIONS
Turbosmart Pty Limited P.O.Box 264 Croydon, NSW, 2132 Australia ABN: 69 081 069 794
Ph: +(612) 9798 2866 Fx: +(612) 9798 2826 Email: [email protected]
PART
NUMBER
FG-ADM-
SUPRA
Step 9.
You should have removed the following from
your Supra: (1) top section of intercooler outlet pipe,
(2) bottom section of intercooler outlet pipe and (3)
intercooler outlet pipe bracket.
Step 10.
Fit the Silicon hose coupler over the Supra
Adaptor. Install your Turbosmart BOV onto the
adaptor by following the instructions included with the
BOV.
Step 11.
Fit the adaptor between the intercooler and
the throttle body. Using the two 90mm hose clamps
supplied, secure the Silicon hose coupler onto the
Soarer adaptor and the throttle body.
Step 12.
Use the 70mm constant tension hose clamp
supplied to secure the intercooler pipe to the other end
of the adaptor pipe. Tighten the hose clamp with a
7mm socket or screwdriver.
Step 13.
Connect the pre-assembled silicon hose
assembly as shown in the diagram below:
Step 14.
Install the 6mm end of the Silicon hose
assembly supplied onto the factory BOV boost/vacuum
source and secure with the 6mm spring clamp
supplied.
Turbosmart
BOV
Supra Adaptor
Connect short 6mm
end to factory BOV
boost/vacuum source
Connect long 5mm end
to Turbosmart BOV
650mm
Top Section
Bottom Section
50mm
Silicon Hose
Coupler
Intercooler
Outlet Pipe
Bracket
Install 70mm
constant tension
hose clamp here
