turbofan E33D5, Инструкция по установке и эксплуатации

Страница: 18 / 25

Controller - Operator Settings
16
Changing Operator Settings
With the Oven in ‘Stand-By’ Mode (i.e. Power to oven but both displays are blank).
1.
ENTERING THE OPERATOR SETTING MODE.
Press and hold 'Steam' and ‘Timer-Start/Stop’ keys together for 3 seconds.
Upper Display will show .
Lower Display will flash .
2.
SETTING PASSWORD (OPERATOR PASSWORD - 123).
Rotate ‘Timer’ knob to set password .
Press ‘Fan Lo’ key to confirm password.
Upper Display will show one of the setting codes, eg.
Lower Display will show the value of the setting, eg.
3.
CHANGING THE OPERATOR SETTINGS.
Rotate ‘Timer’ knob to the setting required.
Press ‘Fan Lo’ key to confirm setting required. Lower Display will flash.
While Lower Display is flashing, rotate ‘Timer’ knob to select value required.
Press ‘Fan Lo’ key to confirm value. Lower Display will stop flashing.
4.
EXITING THE OPERATOR SETTING MODE.
Press ‘On-Off/Light’ key, to return to Stand-By Mode.
Operator Settings
Setting
Number
Description
Default
Setting
Oven Pre-Heat; - (Automatic Pre-Heat Temp on oven start-up).
150ºC
(302ºF)
Light Auto ‘Off’ Setting Time -
0 = ‘On/Off’.
1 = 1 minute auto ‘Off’.
2 = 2 minutes auto ‘Off’, etc.
0
Alarm Volume - Can be adjusted to suit operators preference.
5
Program Pre-Heating Condition - This setting allows for pre-heating ‘Ready’ temperature in
‘Program Mode’ Mode to be set higher than Program Set Temperature.
Factory Default Setting is ‘0’ (Equal to Program Setting). 0
Multi-Stage Enable - This setting enables multi-stage programming. Factory default is
‘YES’, multi-stage programming is enabled. Setting this to ‘no’ simplifies programming and
program cooking.
YES
Setting
Range
60 - 260°C
140 - 500°F.
0 - 60 mins.
0 - 10.
0 - 30°C
0 - 54°F.
‘YES’ or ‘no’.