turbofan e31D4, Руководство по эксплуатации

Страница: 13 / 20

Cleaning and Maintenance
11
Cleaning Guidelines
To achieve the best results, cleaning must be regular and
thorough. If any small faults occur, have them looked at
promptly. Don't wait until they cause a complete
breakdown.
NOTE:
•
Carefully read and follow the safety instructions on
the label of the cleaning product to be used.
•
DO NOT use harsh abrasive scouring pads or
abrasive detergents as they could damage the oven.
•
Ensure that any detergent or cleaning material has
been completely removed after each cleaning.
To keep your oven clean and operating at peak efficiency,
follow the procedures shown below:-
Oven Cleaning
NOTE:
•
If the oven usage is very high, the cleaning
procedure should be carried out on a more frequent
basis.
•
Allow the oven interior to cool to approx 50
˚
C -
120
˚
F before commencing cleaning.
Stainless Steel Surfaces
a. Thoroughly clean the exterior surfaces of the oven
with, a damp cloth moistened with a mild detergent
solution, or a soft bristled brush.
b. Baked on deposits or discolouration may require a
good quality stainless steel cleaner. Always apply
cleaner when the oven is cold and rub in the
direction of the grain.
Side Racks
a. Remove wire oven racks and bottom element guard.
b. Partially undo the rack securing screw (anti-
clockwise) securing side rack to the oven wall, until
the rack is loose.
c. Pull side racks forward to disengage the location
pins at the rear of rack from the rear wall of the
oven and remove the racks from the oven.
d. Clean all racks with a mild anti bacterial detergent
and hot water, using a soft bristled brush.
e. Dry the racks thoroughly with a dry cloth.
f. To refit the racks, engage the locating pins at the
rear of side rack into the locating holes in the rear
of the oven.
g. At the same time locate the front of the rack over
the rack securing screw and hand tighten the rack
securing screw .
h. Refit the wire oven racks and bottom element guard
to the oven.
Lamp Glass / Fan Baffle
a. Remove the wire racks as shown previously.
b. Whilst holding the fan baffle in place, undo the lamp
glass (anti-clockwise) and remove.
c. Pull the fan baffle forward off the location bracket at
lower rear of the oven.
d. Clean fan baffle with mild anti bacterial detergent
and hot water solution using a soft bristled brush.
e. Dry fan baffle thoroughly with a soft dry cloth
before re-fitting.
f. Clean the lamp glass using a soft cloth with a mild
anti bacterial detergent and hot water solution.
g. Dry the lamp glass thoroughly with a dry cloth.
h. Refit the fan baffle onto the location bracket below
the fan.
i. Whilst holding the fan baffle in place, refit the lamp
glass, screw the glass in clockwise to secure the fan
baffle in place.
Do not over tighten lamp glass.
Always turn off electrical power at the
mains supply before commencing cleaning.
This oven is not water proof. Do not use
water jet spray to clean interior or exterior
of the appliance.
Caution
Rack Securing
Screw
Fan
Baffle
Lamp
Glass
Location
Bracket
Unscrew Anti-Clockwise
Rear
Location
Points