Turbo Air TA1500, Руководство пользователя

Страница: 11 / 20

USING THE COMPRESSOR TOOL CONFIGURATION
100L/MIN OIL - LESS COMPRESSOR
11.
Before starting run through this simple list;
1. Ensure the compressor is fully assembled
2. Drain tap – open and drain tank
3. Drain tap – close fully
4. Check power lead for any damage. If damaged have
replaced by an authorised service centre.
5. Plug compressor into a standard 240V 10Amp AC power
point and turn ON.
6. Lift the red button to turn ON, see page 11, Pic.4.
7. Allow the compressor to fi ll the air tank.
8. Turn the compressor OFF.
9. Turn the power point OFF and disconnect the
power lead from the power point.
10. Connect your air hose and air tools.
11. Reconnect to the power lead to the power point and
turn ON.
12. Turn your compressor ON.
13. Once turned on and you begin using the connected air
tools the compressor will start and stop without warning.
This is controlled by the pressure switch. These
pressure settings are factory set and should not be
changed.
Pumping starts at (minimum) 85PSI and stops at
(maximum) 115PSI. Once the initial pump up stage has
fi nished you can use the compressor. Remember to adjust the
outlet air pressure to the tools recommended working
pressure and open the tap fully.
The confi guration of tools and accessories can be varied to
suit your particular requirements. A basic recommended set
up is shown in Pic. 6 (accessories not included).
When you have fi nished using your compressor follow these
simple steps:
1. Turn your compressor OFF, using the ON/OFF button.
2. Turn the power point OFF and disconnect the power
lead.
3. Disconnect your air tools and air hose.
4. Clean your air hose and air tools.
5. Store your air hose and air tools in a secure well
ventilated cabinet.
6. Slowly open the tank drain tap, see page 14. This allows
excess air and moisture, water, to vent.
7. Leave the tank drain tap open. This allows any moisture
to drain while the infl ator is stored.
NOTE: Use of a water trap may be of beni
fi
t to ensure no
water or moisture reaches your air tools.
PIC. 6