Turbo Air Super Deluxe Series, Инструкция по установке и эксплуатации

Страница: 17 / 28

17
FOR FREEZERS
1. Plug in and turn on the power switch located on the bottom of the top grille right
side. The Display panel will be lighted and make a beep sound. The compressor
will begin to run.
2. The default temperature setting is No. “5”.
3. The compressor is automatically cycled by the electronic controller
(PCB, F-Sensor).
4. The Defrost cycle is automatically controlled by the D-sensor, and the PCB.
5. Set level toward “1” for higher temperatures and toward “9” for
lower temperatures.
6. The interior light is activated when the door is opened.
7. Evaporator fan motor(s) will run after all doors are completely closed.
8. Good Air Flow in freezer unit is critical.
Items loaded into the freezer should not be pressed against the back wall and
items should be kept 4inches away from the evaporator compartment.
BASIC OPERATION
TSF-23SD-N
TSF-35SD-N
TSF-49SD-N
TSF-72SD-N
FREEZERS
16
FOR REFRIGERATORS
FAN RUNNING INDICATOR
1. If the fan motor is running, fan running indicator will be turned on.
2. Evaporator fan motor is activated when the door (both doors for TSR-49SD-N6,
all three doors for TSR-72SD-N) is closed.
DOOR OPENING INDICATOR
1. If any door is opened, door opening indicator will be turned on.
2. In case any door was opened for around 30 seconds, warning beep sound will
ring three (3) times.
3. In case of door opened around 1 minute, warning beep sound will ring again five
(5) times.
4. In case of door opened around 5 minutes, the beep sound will ring continuously.
5. The beep sound will stop immediately if door is closed properly.