7
TUNMAGL0100
•
TUNMAGL0300
•
TUNMAGL0600
TUNMAGL1000
•
TUNMAGL2000
•
TUNMAGL3000
•
TUNMAGL5000
v1.3
USER MANUAL
4. OPERATION GUIDE
Ensure that you have read all the safety instructions and checked the equipment for damage before use.
Check that the working environment is suitable for operating the equipment.
REMEMBER:
The magnetic adhesion is highly affected by the composition of the material being lifted. Consider the material type,
weight, condition, strength, density and rigidity of the load that will be lifted. These factors will have an important impact on the
effectiveness of the lifting capacity of the this equipment and user safety.
Alloys with higher iron content are typically more susceptible to magnetic fields than those with lower iron content. Research and
familiarise yourself with the material you are lifting.
IMPORTANT:
Consult the information shown in the manual to make sure the capacity of the equipment is suitable for the load. If
you are unsure - contact your dealer for advice.
•
Ensure the handle is securely attached.
•
Ensure the load surface is clean and free of debris, oil, rust, paint, dirt and other loose debris.
•
Position the lifter on the steel gently so as not to cause damage to the magnetic lifter or the load surface.
•
Ensure that you place the magnetic lifter on the center point of the mass on the material load so that the weight is distributed
evenly on all remaining sides and load is balanced evenly.
•
Press the button at the top of the handle and turn the handle from the “
OFF
” position to the “
ON
” position.
•
Ensure the safety lock is engaged towards the machine to keep the device in the “
ON
” position.
•
Move or lift the load a short distance to ensure the load is balanced.
•
Do not proceed with the lift until the load is balanced correctly - lower and readjust the magnetic lifter as required.
•
To disengage the magnet when in the “
ON
” position, simply press the button at the top of the handle to disengage the lock and
slowly move the handle to the “
OFF
” position.
•
When transporting the device, always carry with both hands.
•
If transporting inside a vehicle, it is recommended to transport it flat so as to avoid the item falling over.
•
Never carry the device by the handle.
5. MAINTENANCE
•
WARNING:
Do not remove the device panel - this should only be removed by a qualified engineer.
•
IMPORTANT:
Magnets inside are extremely strong and adjustments without proper equipment can result in serious injury.
•
Check for any misalignment, damage or loose connections on all moving parts.
•
Protect the magnet from rusting by oiling the bottom base after use.
•
Store equipment in a dry, clean environment.
•
Check the handle before each use to ensure the safety button moves freely.
•
We recommend that an annual calibration check is carried out on this equipment - contact your dealer for advice.
