STEP 1 –
Carefully open box and
remove the Pit Pillow.
STEP 2 —
Open one end of the sealed
Pit Pillow and make a slit at the top. Pull
the plastic from each side, tearing the
plastic off.
STEP 3 –
(3A)
After removing the plastic seal
from the Pit Pillow. (
3B)
Unroll the Pit Pillow
and lay flat on the ground.
STEP 4 —
Allow Pit Pillow to fully
expand before use. (Refer to Pg. 1
based on size of Pit Pillow)
Step 1
Step 2
Step
Step
Step 4
www.tumbltrak.com | 800
-
331
-
4362 | [email protected]
*Note: The cover and foam for the
6’
x8
’
x12
”
Pit Pillow will come unassembled. To assemble unfold and lay the
Pit Pillow cover with the Pit Pillow logo and Velcro facing the floor. Follow the instructions above when unpacking the
foam. Immediately insert the foam in the bottom part of the cover so the Pit Pillow logo will be facing up when folding
the cover over. Fold the top of the Pit Pillow cover over and begin to Velcro one side and work your way around the
Pit Pillow. Allow the foam to fully expand in the cover and adjust foam if needed.
