Place Drawer into the Cabinet
Place the drawer back into the cabinet by extending the drawer slides and snapping the rails on the Retaining
Tabs. You may need an assistant to help align the tabs over the drawer slides. Install the Slide Securing Screws
on each side of the Drawer. (See Detail A on Page 3)
Make Sure the Drawer Functions Properly
Open & close the cabinet drawer to make the sure the drawer is firmly attached to the slides. If the drawer
is not firmly attached, remove the drawer, bend the silver tabs outward and replace the drawer.
Secure the TufBox to Floor
•
Locate the holes on the bottom of the uprights and use the holes closest to the front of the trunk
compartment, nearest to the brake lights to mount the self-tapping screws to the trunk floor.
Because
of the gas tank location, wiring, hoses, etc, it is recommended that there be no additional drilling in the mounting
zones.
(See diagram below.)
1406 Fifth Street, SW • Canton, Ohio 44702 • USA
1-800-321-0870 • 330-452-9132 • Fax 330-452-2557
[email protected] • Tufloc.com