Tufline SPIKE HARROW SH-72 Скачать руководство пользователя страница 7

Safety Rules 5

SAFETY RULES

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

OPERATION (cont’d)

moveable parts even when the engine has 

been turned off. Hydraulic system leak down, 

hydraulic system failures, mechanical failures, 

or movement of control levers can cause

 

equipment to drop or rotate unexpectedly and 

cause severe injury or death.
• Always comply with all state and local laws 

governing highway safety and lighting and 

marking requirements.
• Operate only in daylight or good artificial 

light.
• Keep bystanders away from equipment.
• Keep hands, feet, hair, and clothing away 

from equipment while engine is running. Stay 

clear of all moving parts.
• Power unit must be equipped with ROPS or 

ROPS cab and seat belt. Keep seat belt 

securely fastened. Falling off power unit can 

result in death from being run over or crushed. 

Keep foldable ROPS system in “locked up” 

position at all times.
•  Never allow riders on power unit or attach-

ment.
• Always sit in power unit seat when operating 

controls or starting engine. Securely fasten 

seat belt, place transmission in neutral, engage 

brake, and ensure all other controls are disen-

gaged before starting power unit engine.
• Look down and to the rear and make sure 

area is clear before operating in reverse.
• Use extreme care when working close to fences, 

ditches, other obstructions, or on hillsides.
• Do not operate or transport on steep slopes.
• Do not stop, start, or change directions sud-

denly on slopes. Always operate down slopes; 

never across the face.

• Use extreme care and reduce ground speed 

on slopes and rough terrain.
• Keep alert and watch the front as well as the

rear when operating.
• When making gang adjustments, be careful to 

keep hands and feet clear of sliding parts and 

possible pinch points.

• Stop power unit and equipment immediately 

upon striking an obstruction. Turn off engine, 

remove key, inspect, and repair any damage 

before resuming operation.
• Before leaving operator’s seat, lower lift arms 

and put attachment on the ground. Engage 

brake, stop engine, remove key, and remove 

seat belt.

MAINTENANCE

• Always wear relatively tight and belted cloth-

ing to avoid getting caught in moving parts. 

Wear sturdy, rough-soled work shoes and pro-

tective equipment for eyes, hair, hands, hear-

ing, and head; and respirator or filter mask 

where appropriate.
• Never go underneath equipment (lowered to 

the ground or raised) unless it is properly 

blocked and secured. Never place any part of 

the body underneath equipment or between 

moveable parts even when the engine has 

been turned off. Hydraulic system leak down, 

hydraulic system failures, mechanical failures, 

or movement of control levers can cause equip-

ment to drop or rotate unexpectedly and cause 

severe injury or death.
• When performing maintenance or repairs 

make sure the equipment is in the lowered 

position and both the mainframe and gangs are 

properly blocked and secured to prevent rolling. 

Failure to do so can cause serious injury or 

death.

Содержание SPIKE HARROW SH-72

















Отзывы: