TufFlight Tuf-Yak, Руководство пользователя

Страница: 7 / 52

Page 7
Step 35:
Locate the white plastic piece to
the 6” tapered spar end and trace as shown
Step 34:
Mark the unglued spar piece 3/8”
from the untapered edge as shown.
Step 33:
Draw marks 3/8” from the center
on both sides of the center line.
Step 32: Mark the center line again on the
2” piece applied on top in the last step.
Step 31: Apply the 2” piece as shown Step 36: Cut the white plastic to match the
wood spar’s 6” tapered point
Step 37: Test fit the unglued spar into the
“pocket” made in the previous steps
Step 38:
The unglued spar fits into the
pocket from the right in the above picture
Step 40:
Mark the plastic piece where you
see the line 3/8” to the right of center as shown
Step 39:
Apply the plastic piece exactly to
the 6” tapered spar end as shown
Note, half of this 2”
piece should
“overhang” and
not be glued to
anything at this
point
Make sure spar fits
snugly to the
opposite piece as
shown with no
gaps.
Fix any interference
The plastic is semi-
transparent.
Use a felt tip
marker
Don’t move the
plastic piece for the
next step!
(Note, your
white plastic
piece will
probably be
longer than the
one shown.)