Tubeline TL50LSV, Руководство оператора

Страница: 22 / 66

TL50LSV - Section 4: Adjustments 4-3
Plastic Film Installation
DANGER: Switch control panel to manual wrap mode before changing plastic rolls. Never leave it in
auto wrap mode as co-operator may set a new bale on the table or engange wrap cycle with remote.
Plastic has a natural tack. In the event of the plastic
being stored for an extended period of time the
tack may migrate to the opposite side. To test for
tacky fold plastic inside to inside and pull apart. Fold
opposite way (top to top) to determine tackier side.
The roll of plastic should be installed with the tack
against the bales.
The two metal stretcher rolls rotate at different
speeds. This causes the plastic to be stretched.
Plastic goes over the slow roller first and faster roll
second.
1. Rotate hoop manually until empty plastic wrap
carrier can be accessed from the left safety
guard position. See Fig .1 .
2. Lift handle and insert hoop lock pin through hole
in hoop to lock plastic wrap carrier to desired
height. See Fig .1 .
3. Unfasten rubber latch from inner rear of left
safety guard. See Fig .2 .
Fig .2
Fig .1