Tube-Line TL1700SR, Руководство оператора

Страница: 20 / 55

TL1700SR -
Section 4: Adjustments and Repairs 4-1
Section 4: Adjustments and Repairs
Miter Gear Replacement
•
Remove cover, pulling off the silicon seal.
•
Remove gears by taking nuts off of upright gear, sliding horizontal driveshaft towards driveline to allow
horizontal bevel gear to slide off shaft.
• Install new miter gear(s) by tightening nuts on upright gear, then holding horizontal gear in position while
sliding drive shaft back through it.
• Gears should mesh together so that they are 2 3/4” from bottom to center and do not bind. Front faces are
90° to each other. (
Fig.3.1 )
• Apply gear oil before reattaching shield, making sure to reseal with silicon to avoid contamination and leak.
•
Refill grease box with outer grease zerk, checking level by removing cap. Reinsert cap.
Fig.3.1
Fig.3.2
Driveline Switch
See Fig.3.2 . and DE42788 / DE42789 decals on pg.1-7. Shutdown machine before driveline switch .