Operation
Fundamentals:
The
Organ Drive
has 2 channels and a Bypass.
Channel 1
to create a clean tube sound,
such as soft overdrive and crunch sounds
Activated control elements:
VOLUME 1
, GAIN and
CRUNCH
Channel 2
for generating light to extremely distorted sounds with many sound variations.
control elements:
VOLUME 2, DRIVE, TREBLE, PRESENCE, DIRTY, HARD,
EXTREME, FACTOR, GAIN and CRUNCH
. In principle, a clean tube sound can also be
set in this channel
Caution:
The GAIN control and CRUNCH switches are also active in the second channel, as
channel 1 and channel 2 are connected in series in this operating mode (but without
volume 1)
(This means that all controls except volume 1 are active in channel 2)
BYPASS
The input signal is looped through directly. This is done via a so-called hardware bypass
with a relay, so that no sound influence by electronic components is possible
Basic setting, adjustment of the input level and operation channel 1
Set the
Organ Drive
to Channel 1 (yellow LED) (
BYPASS
off)
CRUNCH
off, set the master volume
control of your organ/keyboard to maximum. Use the
GAIN
control to adjust the sound so that it is as not
distorted or distorted as you wish. If the distortion cannot be adjusted to zero, set the
HIGH
switch to off
and repeat the above setting.
Switching on
CRUNCH
now distorts the sound a bit more. Note that the
CRUNCH
function distorts the
sound over a wider dynamic range (quieter sounds are also distorted, louder sounds do not increase the
distortion as much as usual). The
GAIN
the control can be used to adjust the amount of distortion.
Experienced users can of course also use the volume control on the instrument to adjust the distortion
level if
GAIN is set correspondingly higher.
Since the
GAIN
control is not only used to adjust the distortion in channel 1, but also to adjust the input
level, it is also effective in channel 2.
VOLUME 1
adjusts the volume of channel 1.
Operation channel 2
Set the
Organ Drive
to channel 2 (green LED) (
BYPASS
off).
Use
DRIVE
to adjust the distortion level and
VOLUME 2
to adjust the volume. Please note: if the basic
sound is already distorted in channel 1 with the
GAIN
control, this distortion is adopted in channel 2 and
can no longer be corrected back with
DRIVE
.
With
TREBLE
you can raise or lower the heights. When
PRESENCE
is switched on, a very concise treble
range is raised, whereby the influence of the
TREBLE
control increases.
DIRTY
changes the type of distortion. The sound gets a bit "dirty". Together with
CRUNCH
you can
achieve very groovy sounds.
