Agriculture Drone T1 User Manual
14
2018 TTF All Rights Reserved
Click the parameter setting ( ) on top-right corner, then enter more settings( ).
1. Coordinate rectification
2.
Vibration application (Cell Phone vibration when AB Points setting or AB Points record elimination, choose whether to turn on according
to personal preference.)
3.
Broadcast Function, applicable to AB Points operation at long distance away.
Lithium Battery Maintenance and Use
Charge
1.
Keep away from sharp objects, to prevent the battery from puncturing, resulting in leaking and deflagration.
2.
Avoid heat source when charging considering dissipation.
3.
Try to charge when someone nearby and cut off the power if any problem occurs. DO REMEMBER to outfire with sand instead of water
after deflagration.
4.
Finish charging when each cell reaches 4.2V voltage. A 6S battery is 25.2V after full charged. The charging current of Lithium battery should
be 0.5C-1C of the battery capacity. DO NOT exceed 2C battery capacity. (The charging current of 16000mAh battery should NOT exceed
32A). Try to minimize the times of fast charging. (20A).
5.
Every time after operation finished, battery will get hotter and hotter, as the internal resistance will increase because of long time use of
the battery. DO REMEMBER to charge the battery after it gets back to normal temperature, otherwise the battery will be seriously damaged.
6.
Unplug the battery in time after charging complete. DO NOT get it short circuit.
USAGE
1.
The battery can normally be used to 3.7V per cell. DO NOT over discharge.
2.
DO NOT connect positive and negative in wrong way and get the battery short circuit.
3.
DO NOT use the battery in rainy days.
4.
During normal use of the aircraft, stop immediately when battery bulge, rupture or leakage. If the above occurs during charging, stop
immediately.
5.
Check the voltage of each cell of battery. If it is lower than normal voltage 3.3V/S or the voltage of each cell is unbalanced, then there is
quality problem of this battery.
Battery: DO NOT over discharged or short circuit. DO NOT discharge when temperature is too high or too low. Pay attention to protecting the
voltage.