TT RC Sport Playerunknown's Battlegrounds 4x4 American Pickup Truck, Руководство по обслуживанию, Страница: 18 / 24

WHEEL AND TIRE PREPARATION
輪框與輪胎拆卸
17 >>>
[ 1 ] [ 2 ]
Battery Charging Steps and Safety:
Remove the battery from the vehicle before charging.
Place battery on a fire resistant surface.
Avoid any contact with water or other liquids.
從車台上將電池取出後，請將電池擺放在防火墊上，並且避免接觸到任何液體。
ALWAYS use a compatible charger for charging your batteries.
充電時請選擇適當的USB變壓器。
Never leave the battery unattended while charging. Always disconnect
the charger from the power source when finished charging.
充電時如中途離開，請務必拔除充電線。
Always disconnect the battery when you are finished driving the vehicle.
在不遊玩車台的情況下，請拔除電池的電源線。
Remove wheel lock nut using the Xwrench and detach wheels.
使用內附之六角螺帽套筒板手將輪轂上六角固定螺帽取下。
Remove the wheel cap anticlockwise.
以逆時針旋扭將輪框蓋取下。
Make Sure The Axle Nuts Are Tight Before Each Run
Before operating your vehicle, take a moment to make sure the axle nuts are tight, as they may have loosened during shipping.
The correct size axle-nut wrench is supplied with the truck. Check the tightness of the axle nuts before each run.
Please continue to check tightness prior to operating vehicle each time.
輪胎鎖附步驟加註注意事項
在操作之前請先確認輪胎之固定六角螺帽是被鎖緊的。如未鎖緊，可使用隨車所附的螺帽套筒扳手將螺帽鎖緊。
每趟跑完或是再次出發前請務必檢查固定螺帽是否鬆脫？此車之高轉速與高扭力很可能於每一次的操作時使螺帽漸漸地鬆脫。
BATTERY CHARGING
電池充電指南
USB Charger
TRANSMITTER 2.4GHz SYSTEM
2.4Hz遙控器說明
<<<18
1
5
6
9
2
3
4
8
10
7
1 1
Battery Level Indicator
發射機電源顯示燈
Power Switch
電源開關
Servo reversing switches
正逆轉設定裝置
Steering Trim
轉向微調鈕
Throttle Trim
油門微調鈕
Steering D/R (Dual Rates)
轉向大小動調整鈕
Throttle Trigger
油門控制板機
External Charging Jack
充電孔
2.4GHz Binding
校頻配對設定鈕
Steering Wheel
轉向舵輪
Battery Cover
電池蓋
TRANSMITTER CONTROLS
Green / Red LEDs indicate the battery voltage. If the Red LED flashes, please replace the batteries.
兩顆LED設計顯示發射機電池殘量，若紅色LED燈閃爍時，請更換發射機電池。
Slide to turn the transmitter on or off.
發射機電源開關。
Adjusts the steering in small increments or decrements to run the model straight.
利用此旋鈕，調整設定轉向正確中立點位置。
Adjusts the throttle in small increments or decrements to shift the neutral position.
利用此旋鈕，調整設定油門正確中立點位置。
Turn this knob left or right to adjust the amount of the steering dual rate.
Right to increase dual rate amount and left to decrease the amount.
調整轉向伺服機的行程量。
Pull or push to control the movement of the model.
控制車輛前進或後退的裝置。
For rechargeable NiCd/NiHM battery pack on the transmitter only.
使用充電式電池時，可利用此充電孔，進行充電工作。
The Binding button is located on the top of the 2.4GHz transmitter.
2.4Hz 之 BINDING SW 校頻配對設定鈕，為配對發射接收頻率之用。
Control the steering of the model.
控制車輛轉向裝置。
Slide cover to install or remove batteries.
推移電池護蓋即可取出電池進行更換。
To reverse the servo's rotation direction at the flip of the switch.
The reversing switches are recessed into the transmitter to prevent accidental operation.
依實際使用，控制伺服機作動方向。
發射機各部功能簡介