© TT electronics plc
Issue A 06/2020 Page 6
General Note
TT Electronics reserves the right to make changes in product specification without
notice or liability. All information is subject to TT Electronics
’
own data and is
considered accurate at time of going to print.
TT Electronics Sweden AB
Gullfossgatan 3, 164 40, Kista, Stockholm, Sweden
www.ttelectronics.com/iot
S-2CONNECT Hub
User Guide
6 Installation and usage
1.
Make sure there is no damage to the equipment.
2.
Choose your suitable installation location. Consider the environmental requirements and be advised that this device
contains antennas that could be affected from other equipment within close range.
3.
Connect the power supply
4.
Check the LED’s to verify proper operation
5.
Log in to the webpage provided to make changes in the default configuration.
6.1 Mounting
This product can be mounted on any type of surface with standard screws (not included in the package). It can be mounted
in any desirable direction except that the device should not be mounted with the USB connector upwards if there is any risk
for water or other fluids pouring over the device.
The device can be used as a portable device and does not require fixed installation.
If the product is mounted on metallic surface, or close to substantial amount of metal the antenna performances might get
compromised. For full functioning antenna performance, the device should be mounted not less than 30 mm from metal.
Avoid placing the unit close to powerful electromagnetic equipment.
S-2CONNECT Hub has a high IP-rating and temperature range, and are designed for outdoor use. Ensure the USB cap is
closed when using outdoors. Indoor charging only.
