9) If you are going to power your BTN MASHR module from a standard Eurorack power system, install the 2x5 POWER Header and solder
to the PCB. If you use the PulpLogic style Futaba cable system power instead, install the cable. Be sure to connect the white [-12VDC]
wire to the
W
pad, the red [+12VDC] wire to the
R
pad, and the black [0VDC] wire to the
B
pad:
10) Before soldering the jacks and potentiometer to the PCB, connect the wires for the Arcade Button. These will be inserted through the
“Back” of the PCB – the side with the SMD components. Use 3 - 4 inches (74 - 100mm) of wire for each of the four connections:
11) Install the potentiometer and jacks into the front side of the PCB - DO NOT solder them at this time. Note, the ground pin for the jack
is the one outside of the molded plastic part of the jack. This is the pin that goes towards the center of the PCB:
DIY Build DOC/BOM
PLITKA BTN MASHR
V 2.1
Page 5
