Select 9, then finished setting works
Change Setup:
0 Server configuration
1 Channel 1 configuration
3 E-mail settings
5 Expert settings
6 Security
7 Factory defaults
8 Exit without save
9 Save and exit Your choice ?
In these setting items, only IP address must be set. Other items may be no change to set.
If you enter wrong number by mistake, you'd better to restore above data.
２－２－３．Turn back PC set data
If you change setting data of PC, turn back PC data to initial condition.
Let's try connecting test by optional Windows software such as "telnet".
Example test data is "telnet 192.168.1.55 7777" in MS-DOS prompt screen.
（IP address number must to be set number preliminary. ）
When in telnet operation, send data "VER?" which are expected reply data.
If reply data is like ”1.00 05-07-07", then communication line is right.
"Telnet" function contains hardware and software function, when disconnect line, line must be cut off
by "telnet" software operation before hardware disconnection.
Driver software for USB (Universal Serial Bus) operation is downloaded from our web server.
By installing this software, connecting is done like a COM port connection.
Switch on a NCT08-01, connect USB cable, then there will be message box that shows "New hardware
device was found". According to PC directions, specify the folders of downloaded driver software.
When the driver software installs are done, open the "Control Panel" ( START → Control Panel),
click the "System" icon. Then property display of system appears. Select the "Device Manager".
Confirm the USB Serial Port (Com*) number in the tree between Port display.
Select the USB Serial Port (Com*), click Advanced in Port Setting display. It's possible to change
COM Port number. Click the check box Disable PNP □ , it's possible to short operation time in
connecting USB cable again.
Launch RS-232C communication software such as hyper-terminal including PC.
Set COM port number which is known in previous item, it's need to check communication line is available
or not. In this case It's no need to set baud rate. Send the command data such as "VER?", then get
the reply "1.00 04-09-03", there is no problem for communication
２－３．Setting USB communication
２－２－４．Connecting test
２－３－１．Preparations for setting
２－３－２．Connecting test
12/28
