Cam Clutch Ｍａｎｕａｌ
MI300, MI400, MI500, MI600, MI700
MI750, MI800, MI900, MI1000, MI1100, MI1200, MI1300
Thank you for buying Cam Clutch products.
Before installing or working on the product,confirm it is the correct size by checking its label and
make sure you have the complete set of parts.If any part is missing,contact your distributor
immdiately
This manual should be considered an essential part of the unit and remain with the unit when
redistributed.
1.
Installation
1
．
Inner race shaft bore is finished at H7. The recommended shaft tolerance is h6 or h7.
2
．
In case of interference fit when installing Cam Clutch. The maximum interference is up to 0.025.
In this
case, put the Cam Clutch in the recommended oil at temperature of 80
℃
or less and heat it.
3
．
Attach the swing arm to the outer race by using the outer circumference
of the outer race as a spigot facing, and fix to the tap holes at the end face
of the outer race by the bolts which have a strength class of 10.9 and above.
Recommended tolerance of spigot facing is H6 or H7.
4
．
Use the key in accordance with the JIS B1301-1959(Old JIS)
parallel key: second grade. (The MI750 and above include a
special dimension hardened key. Make the depth of the shaft keyway according
to JIS.) Shaft diameter and key dimensions may not correspond with JIS.
5. Allow a clearance between the top of the key and keyway, and fix the Cam
Clutch axially using an end-plate or snap ring. Never use a tapered key.
6. When fitting the Cam Clutch to the shaft, apply pressure to the end face of
Cam Clutch’s inner race. (Do not strike the outer race.)
7. Make sure the rotational direction of the Cam Clutch corresponds with that of
equipment before installation.
8. In case the thrust load is applied to the Cam Clutch, set up the structure to receive the thrust
load separately.
9. The Cam Clutch is not shipped packed in grease, so apply the appropriate grease to the Cam Clutch
before use.
10. In order to enhance feeding accuracy, make sure to carry out the following:
1) Use an end plate on the shaft end, sufficiently tighten the end face of inner race and fit the key and
keyway.
2) Combine the brake and backstop Cam Clutch.
2.
Lubrication
Recommended oil
1. Use the brand of lube oil listed below or its equivalent.
1) Do not use oil with extreme pressure additives as it will shorten the life of the Cam Clutch.
2) For the Cam Clutch to be able to function correctly with the above oil: the ambient temperature must be
between
－
5
℃～＋
40
℃
. If you intend to run the Cam Clutch at a temperature that exceeds this ambient
temperature, contact TSUBAKI for a consultation.
3) Genuine oil (for indexing:1 liter can)for cam clutch is available. Contact our distributor.
Brand
Sanwa Kasei Kogyo
Idemitsu Kosan
Indexing
Samic Arctic Oil Light
Daphne Oil CR10
