TSST SH-216CB, Руководство пользователя

Страница: 4 / 18

CAUTION: Only 12 cm discs can be used when the drive is installed vertically. Do
not place 8 cm discs in the tray when using the drive installed in this way.
Removing a Disc

Press the eject button. The disc tray will be ejected.

Remove the disc.

Push the button in order to close the tray.
NOTE: During some drive activities, the drive will not allow the tray to open even
when the eject button is pressed.
Usage Guidelines

Do not press down on the disc tray when it is opening or closing.

Do not place objects on the disc tray.

Never use a damaged, broken, scratched, or deformed disc.

Keep the disc tray closed when the drive is not in use.
NOTE: High-speed drives spin the disc at a high rotational speed. If a disc has
printing on only half of the disc, or if there is a slight imbalance in the disc,
the imbalance is greatly magnified by the high speed, causing the drive to
vibrate or produce a fan-like noise. These effects are inherent in the high-
speed technology and do not indicate a problem with the drive.
Emergency Eject
The procedure described below can be used to remove a disc from the drive if the eject button is
disabled by software or a power failure occurs.
1. Turn the computer off.
2. Insert a small diameter rod or a stiff wire (a straightened paper clip about 1.2 mm
[0.047 in] in diameter) into the emergency eject hole and push firmly.
3. The disc tray is ejected by about 10 mm (0.39 in). Pull the disc tray out.
[Remove above section for 12.7 mm and 9.5 mm slot drives when Emergency
eject feature is not accessible to the user.]
NOTE : Do not insert more than 50 mm (1.9 in) in depth.
Inserting more than 50 mm (1.9 in) may damage the drive.
Cleaning Media
 If dust or fingerprints get on the disc, wipe it with a soft cloth from the center to the edge.