2
TSM Products|1500 Clinton Street, Building 123| Buffalo, New York 14206 USA|www.tsmproducts.com
INTRODUCTION:
Congratulations! You are now the proud new owner of a USA Stainless Steel
Meat Cuber. Nearly every component is machinist-made and assembled by us
in Buffalo, NY to a standard now rarely seen. We sincerely hope you enjoy it
and consider Sausage Maker for your future food processing supplies. Thank
You for Supporting American Made.
UPON DELIVERY:
Be sure to inspect that there was no damage to the Meat Cuber and its
components. If there is noticeable damage call Customer Care 1-716-824-
5814. The Meat Cuber and its components are sprayed with a stainless steel
cleaner and thoroughly cleaned prior to shipping, at times there can remain
small amount of residue, this is normal. Disassemble, wipe dry with paper
towel and wash with light-detergent prior to use.
(Caution: Cubing Blades and metal edges are sharp!)
CAUTIONS/WARNINGS:
1. Read the following safety guides, and instructions. Keep instructions for
future use. Failure to follow instructions may cause bodily harm or injury.
2. Keep Cuber out of reach of children at all times.
3. Meat Cuber is intended to be used ONLY with Blade Housing and Combs
properly installed and secured to prevent injury.
4. When handling blades for maintenance or cleaning, Always Use cut
resistant gloves.
5. Keep fingers and hands away from throat of Cuber and away from
underside of Cuber Stand when in use.
6. Bottom of legs and base may have debris that can scratch counter surface,
check and clean if debris is found.
7. Cuber should be secured to flat non-slippery surface with bolt-screws, or
household C-Clamps/Vice Grips prior to use.
8. HANDWASH ONLY with bleach solution or light detergent.
