ENGLISH
ENGLISH – 9
use a non-sharp screwdriver (between pin and visor) to carefully remove the
pins at the ends of the visor and lift the visor away from the helmet.
To replace the visor, center it on the helmet, position the middle pins (if pro-
vided) into the holes and then snap the pins on the side of the visor into the
holes in the helmet (Fig. 1).
Depending on the model your visor offers 3 degrees of vertical angle adjust-
ment; simply tilt the visor up or down to the desired position (Fig. 2). Some
models don’t feature adjustable visors.
Caution
: DO NOT try to remove the visor by pulling forward on the centre.
This will damage the helmet and the visor.
HELMETS WITH LED LIGHT
To remove the LED light push it out of the helmet from the inside with the
help of a pen (Fig. 1). To replace the LED light snap the pins on the LED
light into the holes in the helmet (Fig. 2). To replace the battery on your LED
light, remove the two screws at the base of the light, remove the cover and
the circuit. At the back of the circuit push the battery out with non-sharp tool.
Insert a new battery with + sign up. Put the circuit and finally the cover back
in and close the screws.
Battery included
: Lithium Cell CR2032.
SUBSTANCES
TSG helmets are made of high-tech materials for optimal functionality. Our
durable hard shell helmets are made of ABS, PC or PP plastic, depending
Fig. 1
Fig. 2
Fig. 1
Fig. 2
