TS-market EDIC-mini LCD, Руководство по эксплуатации

Страница: 10 / 40

10 11
Battery is fully
charged Battery is
discharging Battery is
discharged
If the battery is inserted properly, the DVR will execute self-testing,
and you will see the total memory capacity and firmware version on
the display, then all the LCD elements will be indicated for a
moment. After that you will see the following information on the
display:
- In the symbol line battery charge indicator and mode symbol
(Stop mode);
- In the numeric line the current time (hours and minutes), the
separator blinks at a 2-second interval. (Fig. 1) Battery replacement
Battery charge indicator shows how much the battery is discharged.
If the battery is fully charged, the battery indicator border and three
lines inside will be shown on the display
The DVR is in the Standby mode and ready to work. If let w ithout a
push-button activity for a minute, the DVR goes to Sleeping
mode and the LCD display goes off. Push the joystick up to switch
back it
on.
If there is only the battery border on the display, it means that the
battery is discharged and should be replaced. When the battery is
discharged, the DVR does not react to button pressed or pushed,
the display is off.
You can replace the battery without switching off the DVR. At that it
can work for some seconds without the battery. Thus, if the battery
is replaced fast enough, the built-in real time clock does not reset.
Earphone and remote control connection
The earphone and remote control can be connected through the
earphone connector in the side bottom part of the case. You should
insert the earphone plug into the connector up to the stop.
Fig.1