RS-485 (Half duplex)
Half duplex RS-485 interface, RTS for driver enable/disable
RS-422 (Full duplex)
Full duplex RS-422 interface.
TRP-C36 can auto detect interface of serial I/O, Select “Auto’ user may neglect others
selections.
5-1-11 Console command control
This feature will be available soon. The default value is “disable”
5-1-12 Packet mode of serial input
z
Disable : Disable packet mode.
z
Enable: Packet mode enable.
If packet mode is enabled, the data input from UART will be deferred until input buffer full, or,
detection of packet gap in which no more characters arrived.
z
Packet mode inter-packet timeout
Packet gap detection time constants, ranging from 10 to 3000 ms
5-1-13 Device ID
User assigned ID number. 0 - 65535
5-1-14 Report device ID when connected
In TCP mode, if report device ID enabled, when socket connected, TRP-C36 will immediately
report device ID in following formats.
Serial I/O socket
nnnnnA[LF][CR]
Digital I/O socket
nnnnnB[LF][CR]
The total length is 8 bytes. Where nnnnn is 5 digit device ID assigned by user, [LF] is decimal 10,
[CR] is decimal 13
5-1-15 Setup password
Administration password used in Login. The password can be empty or up to 15 character long.
5-1-16 Access password
Authentication password during socket connection can be empty or up to 15 character long. If
password is empty, authentication is disabled. Otherwise, if authentication failed or no password
supplied with 10 seconds, socket will be closed.
Notice: Access password doesn’t mean Login password. But the Setup password is
always same as Login password.
5-2 Setup completely
Press [Update] Button, TRP-C36 will save all parameters into internal non-volatile memory and