Tryax TY30-VS, Руководство по эксплуатации

Страница: 29 / 37

29
6. Troubleshooting
6.1 Machine Troubleshooting
Item Fault reason Factor Handling method
1 X-axis shakes
1. Lack of oil.
2. Wrong oil applied.
3. Oil flow-rate.
4. Level error is too big.
5. Noise in operation. 1. Renew or supplement oil.
2. Use SHELL R68 guide-way oil.
3. Noise is shown; need to be replaced.
4. Re-adjust level.
5. Track lubrication is abnormal; check the
lubrication system.
2
X-&Z-axis
won’t move
1. Fuse is burnt.
2. AL trips.
3. Touch to the limit.
4. Operation fault.
5. Wire broken
6. Bearing is stuck.
7. Screw faults.
8. Motor is heated.
9. Motor won’t run. 1. Replace.
2. Record the fault signal; contact related entity to
handle it.
3. Be careful.
4. Contact related entity to handle it.
5. Check if related system/parts fault?
6. Replace.
7. Replace.
8. Check motor load, wire connectors and
overload protection relay; clean up motor
external surface.
9. Replace.
3
X-axis, Z-axis is
not lubricated
1. Fuse is burnt.
2. Thermo-timer trips.
3. Wire broken.
4. Electric Lubricator
5. Filter or Oil-hole outlet is stuck. 1. Replace.
2. Check if there is any other reason that causes
the trip.
3. Contact the service personnel to handle it.
4. Replace.
5. Shutdown; clean the filter & oil-hole.
4
Spindle cannot
run
1. Fuse is burnt.
2. Thermo-timer trips.
3. Wire broken.
4. Motor malfunctions.
5. Spindle bearings fault. 1. Check if parts are disorder?
2. Check if parts are disorder?
3. Check if parts are disorder?
4. Contact the service entity to handle it.
5. Contact the service entity to handle it.
5
X-&Z-axis
speed is
abnormal
1. Guide-way is not oil-lubed.
2. Motor malfunctions. 1. Timely add lube oil.
2. Contact the service entity to handle it.