Truxta QUADro Q300G, Руководство оператора и список запчастей

Страница: 9 / 24

Page 9
OPERATING THE TRUXTA
1.
Start the engine by putting the throttle to the run position and turning the
ignition on. (use choke if cold)
2.
Grip the dead man lever and hold it down.
3.
Use the forward and reverse levers to control direction of travel and speed.
4.
Never press both levers at once or whilst the dead man is released as this will
cause unnecessary strain on the operation cables
EMPTYING THE SKIP
1.
Stop the machine by releasing the Drive Lever followed by releasing the dead
man Brake Lever.
2. Once the machine has become stationary, pull the Skip Release Lever and the
Skip will tip forwards disposing of its contents.
3. When the Skip is empty, push back to its original position. The Skip will lock
into place automatically.
4. Do not use the skip as a levelling blade as this could result in damage to the
tipping under carriage.
PRE START UP INSPECTION
The following pre-start-up inspection must be performed before the start of each work
session or after every four hours of use, whichever is first.
Please refer to the service section for detailed guidance.
If any fault is discovered, the TRUXTA must not be used until the fault is rectified.
1.
Thoroughly inspect the TRUXTA for signs of damage.
2. Check components are present and secure.
3. Check fluid lines, hoses filler openings, drain plugs and any other areas for
signs of leakage.
Fix any leaks before operating.
4. Check the engine oil and fuel levels and top up as necessary.
5. Check the tyre pressures and top up as necessary.
PETROL - OPERATING INSTRUCTIONS
If it is necessary to travel down a slope of more than 5° when fully laden, ensure that the
machine is turned round and reverse down the slope.