TRUST WIRELESS POWER SYSTEM 310SY
2
3 Installation
Note:
Check the capacity of the lamp you want to connecist; you can dim and
switch a maximum of 400 Watts with the WIRELESS POWER SYSTEM
310SY dimmer.
3.1 Dimmer
1.
Set your home code (A t/m P) to the WIRELESS dimmer by means of the
rotation switch on the back. Select a home code which is not in use by other
devices in your vicinity but which is the same as the one for the remote control
you are using. See figure 1.
2.
Next, set the selected device code (1 through 16) with the second rotation
switch. See figure 2.
3.
Plug the switch into the power outlet.
4.
Next, insert the plug of the lamp you want to operate by remote control into the
dimmer. See figure 3.
5.
If the lamp has its own on /off switch, switch it on.
Now you can dim the lamp you connected and switch it on and off if you have entered
the correct channel settings on your remote control.
Note:
Only use dimmers with light bulbs.
Note:
When using several dimmers, do not use the same device code.
3.2 Remote
control
Before you can operate your devices with the WIRELESS POWER SYSTEM 310SY
remote control, the particular devices must first be connected to the Trust WIRELESS
POWER SYSTEM 3201Y switches or other receivers from the Trust power 300 series
3.2.1
Inserting the batteries
1.
Remove the battery compartment cover. See figure 4.
2.
Insert the 23A 12V (B) in the compartment (C) with the “+” pole to the “+” pole
of the remote control and the “-“ pole to the “-“ pole of the switch. See figure 4.
3.
Replace the battery compartment cover.
Note:
Remove the battery if you do not use the remote control for an
extended period.