Truper SINCO-10X2, Руководство пользователя

Страница: 23 / 32

Parts
Unpacking and assembly
7
Mounting onto a work bench
Cutter head release
6
3
Due to tight quality controls there is a small probability that
the tool has defects or missing parts. If there is any
problem, before using the tool and to prevent severe
injury, please go to a Authorized
Service Center.
• Remove all loose parts from the packaging before
unpacking the tool.
• Remove the packing material around the tool.
• Carefully lift the saw grasping only by the carrying handle
(
6
). Sit the unit onto a totally leveled surface.
• Always carry the tool with the cutter head set down and
blocked with the lock knob (
3
). Lift the saw only using the
carrying handle.
Prevent back injury. Seek help to lift the saw.
• Find four orifices in each one of the four supports to fix the
base onto a worktable.
• Fix the base onto a perfectly leveled worktable. Use
screws (not included).
• Or, fix the base onto 1/2” or larger piece of plywood to
be able to fasten the board to the table or to carry it to
different work places.
• Assembling the tool onto a warped,
tilted or irregular surface will cause uneven cuts.
WARNING
• Once the tool is assembled, use the lock knob ( 3 ) to free
the cutter head and use the saw.
• Press down the cutter head while pulling out the lock
knob.
• Then lift the cutter head slowly, until it stops again with
the lock that is outwards.
• Release the lock.
• To secure the cutter head again, lower it to the top of the
cutter head, without releasing the cutter head, push the
lock up to the bottom and release both.
11
3
35
4 4
5
29
24
24
31
14
16
34
27
17
12
2
22
20
17
18
19
23
ENGLISH
DRAFT
DRAFT
DRAFT