Truper COMP-12S, Руководство пользователя

Страница: 20 / 24

8
B
A
ENGLISH
Maintenance
• Disconnect the equipment from the power supply and
release all the pressure from the system before trying to
install, servicing, relocate or carry out maintenance.
• Always have the vents clean and free of obstructions to
guarantee an adequate motor cooling.
• Inspect regularly all the mounting screws and double
check for tightness. If any of the screws is lose, tighten
immediately.
• Any other service or repair to the compressor shall be
carried out in a Authorized Service
Center. Service and maintenance carry out by
non-certified people may cause personal injuries and
make the Warranty void.
Cleaning and care
• Check the safety valve before each use.
• Wear safety eyeglasses.
• Turn ON the compressor and allow the tank to fill.
• When the compressor shuts OFF automatically, press
the ON / OFF switch into the OFF position (
O
)
• Pull the safety valve ring a few seconds to release air.
ALWAYS put your face away from the air stream. Release
the ring.
• If air is leaking before releasing the ring, DO NOT use
the compressor and go to a
Authorized Service Center to replace the safety valve.
• Using the compressor with a valve in
bad repair may result in death or severe body injuries.
Safety valve
Maintenance
Service
DANGER
• After each use, disconnect the compressor and release
the air pressure from the tank by pulling the safety valve
ring (
A
).
After releasing all pressure, open the drain valve ( B ) to
remove the water stored in the tank by condensation.