Rotation selector
button in the
drilling position.
Chuck
Bit
Chuck
wrench
Turn on and operation control
• Intermittent operation:
Connect the plug into the power inlet.
Press the switch (
A
) to start the hammer drill.
To stop, just release the switch.
• Continuous Operation:
Connect the plug into the power inlet.
Press the switch (
A
) and block it pressing the continuous use button (
B
).
To stop, press and then, release the switch.
Rotation direction
• The rotation direction button is located on both sides of
the drill (
E
).
• To make the drill turning forwards and drill, press the
rotation direction button with the arrow pointing towards
the chuck.
• To make it reversible press the rotation direction button
with the arrow pointing towards the drill handle.
• The reverse rotation enables the drill to loosen screws
and nuts turning the drill into a screwdriver. When using
the drill in the screwdriver mode do not exercise too much
pressure onto the switch.
• Changing the rotation direction can only be carried out
when the switch is not pressed.
Bit fitting
• Put the bit into the chuck until it stops.
Fasten with the chuck wrench and tighten
alternately the chuck into each of the orifices.
Changing from hammer drill to drill
• To drill concrete, floor tile or materials of similar
hardness, turn the impact-rotation selector (
D
) completely
into the IMPACT ( ) position (pointing towards the
chuck). The bit will simultaneously impact and rotate onto
the material.
• To drill metal, wood or plastic, move the impact-rotation
selector completely into the ROTATION ( ) position
(pointing towards the chuck). The bit will rotate onto the
material.
Do not try to drill metal; wood or
plastic with the hammer drill into IMPACT ( ) mode
setting. Otherwise the tool efficiency will lessen and the
bit tip would get damaged.
7
Start Up
D
A
B
E
ENGLISH
WARNING
