Trumpf TruConvert AC 3025, Руководство оператора

Страница: 69 / 80

Setting the system configuration
Conditions
■ Operation via web-based user interface
■ Devices (AC-DC module, DC-DC modules) are connected to
the system control
1. To switch on the system control and the modules: switch on
the 24 V supply voltage.
1 Most recently saved configura-
tion is displayed as the sug-
gested value. 2 Most recently saved configura-
tion 3 Most recently saved configura-
tion does not match the
detected configuration.
Input screen "System Configuration" Fig. 36
The input screen "System configuration" is displayed.
The connected devices do not match the expected configura-
tion, i.e. the most recently saved configuration.
Status LEDs on the system control: All 3 LEDs flash syn-
chronously.
Status LEDs on the AC-DC module: The green and red
LEDs light up and the yellow LED flashes.
2. In "Select configuration", select the present system configura-
tion:
−
0: No configuration
This configuration only occurs in the event of an error,
e.g., if there is no connection to the modules (check
cables) or if an incorrect module type was detected
(check alarm messages).
− 1: Simulator
The system control alone is used and connected mod-
ules are simulated.
A67-0141-00.BKEN-
001-05 2020-06-10 Operation
63