OPERA
TIONS MANU
AL
13
If your laser is water-cooled, your laser comes with a kit containing the parts required to
connect your laser to your chiller (chiller not provided). If assistance is required, Access
Laser Company would be happy to answer your questions.
For optimal performance with your water cooling system, keep the laser balanced, cool
the laser equally, and keep the laser stable. The quick connect tubing fittings are made by
PISCO (www.pisco.com). These fittings are easy to use.
Assemble the PISCO fittings
1. Cut the end of the tubing clean and flat.
2. Ensure that the outer surface of the tubing is free of defects for the first ½” (13mm)
3. Ensure that the tubing is round (not distorted).
4. Verify that the tubing is the correct diameter for the fitting.
5. Insert the tubing into the fitting and push it in as far as possible. It should go in
approximately 0.7” (18mm)
6. Pull gently on the tubing to verify that the small Stainless Steel teeth in the fitting are
grabbing the tubing securely.
7. The fitting is ready to be used.
To Remove
1. Push the tubing gently into the fitting.
2. Push the ring into the fitting. This will release the small Stainless Steel teeth
from the tubing.
3. While holding the ring close to the fitting, gently pull the tubing out of the fitting.
4. The fitting can be removed and replaced on the tubing many times, until the end of
the tubing becomes scratched. If the end of the tubing is scratched, it should be cut
back to expose smooth surface.
To Operate
1. Always turn on/off the water chiller and the laser power at the same time.
2. If the coolant is running while the laser power is off, condensation can occur. This
will damage the laser electronics.
Water Cooling Connection Instructions
2211 W. Casino Rd Suite A Everett, WA 98204
Phone: 425-582-8674 Fax: 425-582-8679 Email: [email protected]
