4
When the Trumove S / T is switched off
using the remote control, the control unit
remains in standby. In order to switch off com-
pletely the battery must be disconnected or
switched off using the isolating switch.
Batteries
We recommend the Truma Mover® PowerSet which contains
batteries with round cell technology and a matching charger
to ensure optimum operation. Drive, lighting and gel batteries
with adequate capacities are also suitable.
Recommended battery capacities
Round cell technology
min. 55 Ah
Gel / AGM
min. 70 Ah
Lead-acid battery (liquid electrolyte)
min. 80 Ah
Starter batteries are not suitable
Batteries with a greater capacity allow longer operation.
Charger
To ensure that the batteries are charged to the optimum, we
recommend the Truma charger BC 10 that is suitable for all
battery types up to 200 Ah.
Battery care (also maintenance-free batteries)
The following points should be observed to extend the
battery life:
– Batteries should be fully charged before and after they have
been used.
– Disconnect from the power circuit in the case of longer
standstills (e.g. with a circuit-breaker or by disconnecting
the battery terminal).
– In the case of longer standstill periods, the battery must be
disconnected and charged for 24 hours at the latest every
12 weeks.
Store fully charged batteries in a cool but frost-free place
during the winter and recharge regularly (every 12 weeks)
Function description
Always observe the operating instructions and “Safety
instructions” prior to starting!
The vehicle owner is re-
sponsible for correct operation of the appliance.
Please note that the Trumove S is only suitable for
single-axle towed vehicles, and the Trumove T is only
suitable for dual-axle towed vehicles.
The Trumove S / T is a manoeuvring system with which a
caravan can be moved without the assistance of a towing
vehicle.
It consists of two separate drive units, each of which has a
12 Volt DC motor. These units are attached to the frame of the
vehicle near the wheels and are connected by lateral bars.
Once the drive rollers have been engaged to the tyres using
the remote control, the Trumove S / T is ready for operation.
All operation takes place using the remote control. This trans-
mits radio signals to the control unit. A separate 12 V lead-
acid battery or suitable lead-gel battery (not included in scope
of delivery) supplies the control unit with current.
Operating instructions
Remote control
a = On / Off slide switch
❙
On (green LED illuminates)
Off (green LED goes off)
b = Caravan forwards (both wheels
rotate in forwards direction)
c = Caravan reverse (both wheels
rotate in reverse direction)
d = Caravan right forwards
(left wheel rotates in forwards
direction)
e = Caravan left forwards
(right wheel rotates in forwards
direction)
f = Caravan right reverse (left wheel
rotates in reverse direction)
g = Caravan left reverse (right wheel
rotates in reverse direction)
Fig. 2
Trumove S only
The caravan can be turned in a circle on the spot without
moving forward.
d + g = Turn caravan to the right
(left wheel rotates fo right wheel rotates
backwards)
e + f = Turn caravan to the left
(left wheel rotates bac right wheel rotates
forwards)
Trumove T only
Turning on the spot without moving forward is not possible
because of the two axles. Pressing the d, g, e or f buttons
causes the Trumove T to move in a circle, whereby the outer
motor runs continuously and the inner motor pulsates.
Trumove S / T
h = Two-hand operation,
engage
drive rollers
i = Two-hand operation,
disengage
drive rollers
To engage and / or disengage the drive rollers
both keys
always need to be pressed at the same time
for about
3 seconds (safety lag) until the drive rollers start to engage or
disengage.
The keys can be released again when the drive rollers move
toward the direction of the respective final position. The drive
rollers reach their final position automatically.
Pressing the two buttons for disengaging whilst the
Trumove S / T is engaging causes the procedure to be
aborted. The drive rollers will disengage and automatically
move to the end position.
The remote control switches off:
– after approx. 2 minutes, if no button is pressed
– after approx. 7 minutes, if one of the movement buttons is
permanently held down. The green LED goes off.
To reactivate the remote control, move slide switch to “Off”
and then back to “On”
❙
after approximately 1 second.
There is no “On / Off” switch on the caravan to be operated.
