Step 3: Remove the fuse cover and replace the fuse.
Step 4: Put the rear panel and bottom rubber panel in position and install the screws.
AIR COMPRESSOR
Read the instructions of the product being inflated before using the compressor. Avoid over inflation; do NOT exceed the
manufacturer’s recommended pressures. Do NOT leave the air compressor unattended during use.
1. Take the air compressor hose out from the storage compartment in the back.
2. Connect the adapter to the valve stem and close the thumb latch.
3. Press Air Compressor On/Off button (the gauge will illuminate immediately) to start power and observe the air compressor
gauge until it reaches the desired pressure. Do NOT leave the air compressor unattended during inflation.
4. Open the thumb latch and remove the connector from the valve stem.
5. Do NOT run for more than 10 minutes at a time. Allow the jump starter to cool down for 10 minutes before using again.
6. Store the compressor hose in the storage compartment when not in use.
ESTIMATED TIME FOR INFLATING
Car tire
5
– 9 MINUTES
Bike tire
25 - 30 SECONDS
Sport balls
30 SECONDS
These times are approximate. Use the air compressor gauge to ensure the proper pressure has been reached. Do not overinflate.
SUPPLY TO 230V DEVICES
The inverter in this product uses a modified sine waveform, which is not quite the same as power company electricity. We
strongly recommend that you check the device’s manual to make sure it is compatible with modifies sine waveform. It is
important to know the continuous wattage of the device you plan to use with the inverter. The JST95012V must be used
with devices drawing 200 watts or less. If powering more than one device, start one device at a time to avoid a power surge
and/or inverter overload. The surge load of each device should not exceed the inverter’s continuous operation wattage rate
.
POWERING A 230V AC DEVICE:
Plug the device into 230V AC power outlet on the front panel. Press 230VAC Power On/Off button first, then turn the device on.
NOTE:
When this product acts as a power inverter, it sounds an alarm to alert you that it is in low voltage protection. The
inverter also features short circuit, overheat and overload protection.
WARNING: RISK OF ELECTRIC SHOCK:
Incorrect operation of this product may result in damage and personal injury. The
output of this product is 230V AC and can shock or electrocute the same as any ordinary household AC wall outlet.
NOTE:
The maximum continuous load is 200 watts. Do not use the inverter with a product that draws more than 200 watts, as
this may cause damage to the inverter and the product.
SUPPLY 120V
AC DEVICES
ESTIMATED
WATTAGE
ESTIMATED
RUN TIME
Spotlights, Sump
pumps, DVD players,
100 watts
1.22 HOURS
TVs, Small power
tools
150 watts
49 MINUTES
Computer, Medium
power tools, Blenders
200 watts
37 MINUTES
