Trueshopping BC1E34F, Руководство пользователя

Страница: 9 / 17

(2) Clamp
(3) Main pipe
(4) Safety guard

THROTTLE WIRE
After fitting the wire, make sure that the throttle cable is put into the throttle lever. If this is not done, it
is very dangerous because the engine will rotate after releasing the throttle.
1. Hook the cable into the hole on the throttle lever. Set
the cable in the lever as shown in the picture. (F4)
2. Wrap the band so that the throttle wire is fixed with the handle.
(1) Hole
(2) Throttle cable
 ADJUSTING THE THROTTLE CABLE
1. After releasing the throttle lever, pull the throttle wire. The normal
play is 1 or 2 mm when measured at the carburetor side end.
2. If there is too much, or too little play, take off the air cleaner cover,
loosen the lock nut and adjust the play. (F5)
(1) Adjust nut
(2) Lock nut
 INSTALLING THE METAL BLADE (F6)
1. Set the inner holder to the gear shaft, and turn to fix with the attached shaped bar.
2. Put the blade on the inner holder with letters to the gear case. And match correctly the hole in the blade to the
projection of the inner holder.
3. Set the outer holder to the gear shaft with the hollowed face to the blade.
4
4. Put the attached bolt cover on the outer holder and secure it with the
bolt (left screw) together with the spring washer and the washer.
(1) Adjust nut
(2) Lock nut
(3) Washer
(4) Outer holder
(5) Blade
(6) Gear shaft
(7) Bar
(8) Inner holder
(1)
(9) Gear case
 INSTALLING THE NYLON CUTTER (OPTION) (F7)
1. Set correctly the inner holder and the outer holder to the gear shaft.
Owner manual
WARNING
9