Truen NCAM-531BIR, Руководство пользователя

Страница: 11 / 44

NCAM-531BIR User Manual
1.3 Megapixel IP Camera Manual
11/44
2. Installation
Connecting Power
1. Carefully check the voltage and current capacity of the rated power.
2. After confirming the power source, connect power adaptor and connect the 12V DC connector to
the system
Connecting Network
1. Plug network cable to Ethernet port (RJ-45 network port).
Connecting Video
1. To display video through the composite video output, connect to a monitor using BNC coaxial
cable
2. Set Enable Preview option “ON” on the Video tab of web page.
(Please refer to the Video Configuration part)
In case that video transmission distance is long, video data may not be transmitted due to a
reduction in the video signal. In order to prevent it, install a repeater in the middle.
Connecting Audio
Audio is full-duplex. It is possible to set the mode as Tx-only, Rx-only or Tx-Rx.
1. Connect audio input and output ports to audio devices accordingly.
2. The Audio signal required is line level, so an audio equipment with an amp, mixer or other amplifier
should be used.
Connecting Sensor and Alarm
Connect sensor and alarm devices to corresponding terminals accordingly.