INSTALLING YOUR CONCRETE SINK USING
“J1” (ADJUSTABLE) BRACKETS IN COMBINATION WITH “T” BRACKETS
FSB-T
FSB-B1-AS
FSB-B1-AL
TOOLS NEEDED
APPLICATIONS
INCLUDED HARDWARE
T Bracket
5/16” x 2-1/2” hex head wood screw
(5 per bracket)
Pencil
Tape Measure
Laser level
Torpedo level
2 C-clamps
Drill
3/16” drill bit
5/16” drill bit
1/2” socket
1/2" box wrench
9/16” socket
Silicone
*MOUNTING TO STEEL STUDS (MIN. 18 GA)
Although these brackets are engineered for both
wood and steel studs, Trueform strongly
recommends outfitting the wall with wood studs
when possible. Therefore, mounting screws are
not
included for steel stud applications.
If brackets must be installed on steel studs,
we
recommend using 5/16” hex-head sheet metal
screws
. Also note that applicable steel studs
should be no thinner than 18 gauge.
MOUNTING TO WOOD STUDS
Complete mounting hardware is included for wood
stud applications only.
Trueform
Adjustable Stud Brackets
and
T Brackets
can be mounted to either wood studs or steel* studs.
Each Adjustable Stud Bracket (FSB-B1-AL
or FSB-B1-AS) includes the following:
Part B1
Part AL or AS (depends on sink depth)
3/8” swivel foot (1 per bracket)
3/8” x 2” hex head screw (1 per bracket)
5/16” x 1-1/2” hex head wood screw
(2 per bracket)
5/16”-18 x 1” bolt (2 per bracket)
5/16”-18 nut (2 per bracket)
