INSTALLING YOUR CONCRETE RAMP SINK USING
ADJUSTABLE STUD BRACKETS
FSB-B1-AS
FSB-B1-AL
TOOLS NEEDED
APPLICATIONS
INCLUDED HARDWARE
Pencil
Tape Measure
Laser level
Torpedo level
2 C-clamps
Drill
3/16” drill bit
5/16” drill bit
1/2” socket
1/2" box wrench
9/16” socket
Silicone
Each Adjustable Stud Bracket (FSB-B1-AL
or FSB-B1-AS) includes the following:
*MOUNTING TO STEEL STUDS (MIN. 18 GA)
Although these brackets are engineered for both
wood and steel studs, Trueform strongly
recommends outfitting the wall with wood studs
when possible. Therefore, mounting screws are
not
included for steel stud applications.
If brackets must be installed on steel studs, we
recommend using
5/16” hex-head sheet metal
screws.
Also note that applicable steel studs should
be no thinner than 18 gauge.
MOUNTING TO WOOD STUDS
Complete mounting hardware is included for wood
stud applications.
Trueform
Adjustable Stud Brackets
can be mounted to either wood studs or steel studs*.
Part B1
Part AL or AS (depends on sink depth)
3/8” swivel foot
(1 per bracket)
3/8” x 2” hex head screw
(1 per bracket)
5/16” x 1-1/2” hex head wood screw
(2 per bracket)
5/16”-18 x 1 bolt
(2 per bracket)
5/16”-18 nut
(2 per bracket)
