Chef Base Series
www.truemfg.com
TEC_TM_159 | REV. A | EN
07/6/2022
Page 6 of 19
Fig. 1.
Remove the exterior packaging.
Fig. 2.
Remove the shipping bolts.
Installation
Uncrating
Required Tools
Required tools include (but may not be limited to) the following:
• 9/16 Socket Wrench
• Phillips screwdriver
• Level
Procedure
1.
Remove the outer packaging (cardboard and bubble wrap or
Styrofoam corner and clear plastic). See fig. 1.
2.
Inspect the unit for concealed damage.
3.
Remove the wooden skid. Set the skid aside.
NOTE: Move the unit as close as possible to the final
location before removing the wooden skid.
a.
Position packing material behind the appliance to protect
the appliance.
b.
Carefully lay the unit on its back
c.
With an adjustable wrench, remove all shipping bolts
securing the wood skid to the bottom of the appliance. See
fig. 2.
4.
If leveling legs or castors
will not be used
, carefully lift the
appliance upright and position the unit in its final installation
location.
If leveling legs or castors will be used, proceed to leveling leg
or castor installation instructions.
NOTE: DO NOT lift the unit by the countertops, doors,
drawers, or grills.
NOTE: Be sure to leave the unit upright twice the time it
was laying down (up to 4 hours) before restoring power. If
this time exceeds 4 hours, let the unit stand upright for 24
hours before powering the unit.
NOTE: Keys for cabinet with door locks are located in the
warranty packet.
WARNING
– Units may pose a tipping hazard
while uncrating, during installation, or when
moving the unit.
