True TBC-24-R/L-OG-B, Инструкция по установке

Страница: 31 / 67

2 9
15 INCH & 24 INCH INSTALL GUIDE
INS TALLING DR AF T S TANDARD AND HOOK UP
Required Tools:
•
Phillips Head Screwdriver
•
Adjustable Wrench
•
3/8” I.D. plastic tubing (3’)
•
(2) Hose clamps
PARTS IN KIT:
1. CO2 Tank (Shipped empty. Fill before use)
2. Draft Standard
3. Draft Standard Screws
4. Draft Head
5. CO2 Pressure Regulator (single version/double version)
6. Chill Hose
7. Rubber Washer
8. CO2 Hose
9. Securing strap
10. Beer Tapper (Sankey, low profile tapper)
CAUTION : FILLED CO
2
TANKS ARE POTENTIALLY DANGEROUS BECAUSE OF THE PRESSURE
THEY CONTAIN. IF YOU ARE UNFAMILIAR WITH THEIR USE OR THE USE OF THE
CO
2
REGUL ATOR, SEEK INFORMATION FROM YOUR CO
2
SUPPLIER.
1. Place rubber washer over draft standard mounting holes.
2. Secure the draft standard to the cabinet with the screws provided.
3. Install the draft head.
4. Remove the draft cap and run the chill hose to the top of the draft standard. Hook the hose onto the
stainless tube to keep hose from falling out (This hose will keep the draft standard cold).
5. Reinstall the draft cap.
6. Hook up the pressure regulator to the CO2 tank. Using a adjustable wrench make sure the nut is tight.
7. Place CO2 tank in the unit using the black strap provided. To secure the tank use one of the screws from
the evaporator cover. Connect the beer hose line from draft tower to tapper. NOTE: Make sure clamp is on
the hose prior to attaching.
8. Tighten the clamp down on the beer line hose.
9. Connect the CO2 hose to tapper. NOTE: Make sure clamp is on the hose prior to attaching.
10. Tighten the clamp down on the CO2 hose.
11. Install the beer tapper onto the keg. The tapper has notches that must line up. Once the notches are
lined up, turn the tapper to secure it to the keg.
1
2
3
4
5
6
7
8
10
9