![TruckCraft TC-503 Скачать руководство пользователя страница 8](http://html.mh-extra.com/html/truckcraft/tc-503/tc-503_owners-manual_1173982008.webp)
Copyright 2018 TruckCraft Corporation Rev. 3/2018
TruckCraft Corporation
5751 Molly Pitcher Hwy
South
Chambersburg, `PA 17202
TC
-
503 Dump Bodies
Tel. (800) 755
-
3867
Fax. (717) 375
-
2975
E
-
Mail:
Web: www.truckcraft.com
be drilled in the sub
-
frame
as required. Use shims sup-
plied to fill any gaps be-
tween the mounting brackets
and the frame or sub
-
frame.
Mark the location for mount-
ing holes in the frame and
drill 8 holes (12 on TC
-
430)
21/32”
diameter for
5/8”
grade 8 bolts supplied.
Caution:
Be careful of wir-
ing, brake lines, etc. inside
frame when drilling. Install bolts, nuts and 2 washers per hole and torque
to 180 FT
-
LBS.
3.
Route control cable into cab and install remote control box in an area
where the up button will not be unintentionally bumped.
4.
Route power supply cable to battery and hook up leads to battery.
5.
Make sure all blocking and tie
-
downs used for shipping are removed. Acti-
vated the remote control up button and carefully raise the body. Do not
reach under or place any body parts under the dump body. Raise the
body up about half
way to about 30 de-
grees from horizon-
tal. Rotate the safe-
ty prop counter-
clockwise until it
rests on the angle
stop on the hoist
-
see figure 6. Care-
fully lower the hoist
until the cross shaft
of the hoist rests on
the prop.
Do not
power down the
hoist after the
shaft rests on the
prop.
With the prop
in this position it is
now safe to work under the dump body.
CAUTION:
✓
The TruckCraft assembly is designed to bolt to the truck frame. No weld-
ing is required.
Do not weld any part of this assembly to the truck
frame.
✓
Openings have been provided in the side of the sub
-
frame for fuel tank
fill spouts. If additional holes are required in the sub
-
frame, the holes
must be a maximum of
2.5”
in diameter and centered in the web. Never
6