43
8
» Pneumatic Disc Brake SL7 - SM7
CALIPER REPLACEMENT
8.2.15 - Fitting cover to stop, final position protruding
2 mm
8.2.15 Press the mandrel of the press-in tool (
T26
) firstly by
hand until it stops, then, using a hammer on the mandrel,
insert the cover to the end stop (see Fig.).
Note:
After fitting the new cover (10), ensure that it protrudes
2
mm
from the plane surface of the caliper (see Fig.).
The inner boot (9) must be in a compressed
condition otherwise the caliper´s freedom of movement
will be limited.
8.2.16 - Insert Cap into Guide Pin using tool (
T11
)
Cap (68a; Rubber Bush) - Floating Bearing Side
8.2.16 Fit the cap (68a) using tool (
T11
) and a hammer. Force
the cap into the guide pin (4a) until firmly seated. The seal is
achieved by the compression of the lip of the rubber bush
(6a) between the guide pin (4a) and cap (68a) (see Fig.).
Cap (68f; Double Roll Bearing) - Floating Bearing Side
8.2.17 Fit the cap (68f) using tool (
T11
) and a hammer. Tap
the cap into the double roll bearing’s guide pin until firmly
seated. The seal is achieved by the compression between the
cap (68f)lip of the double roll bearing (6f) (see Fig.).
Don‘t deform or overstretch the sealing lip of the
double roll bearing (6f). (see detailed Fig).
8.2.17 - Insert Cap into Guide Pin using tool (
T11
)
2 mm
10
T26
T11
68a
6a
4a
T11
68f
6f
6f
