Instruction Guide and Owner’s Manual
In-Ceiling Architectural Speakers
GP-4 • GG-4 • GP-6 • GG-6 • GP-8 • GG-8 GPD-6 GGD-6
Thank you for purchasing this TruAudio
product. Like all of our products, if installed
correctly, these speakers will bring you years
of outstanding audio and video listening.
Please make sure you take the time to read the
complete instruction manual before starting the
installation. If you have any questions,
concerns or comments, call our main office,
888-858-1555 and thanks again.
Please NOTE: These speakers should only be
installed by a TruAudio Certified Dealer. If
these are NOT being installed by one of these
dealers, the warranty could be void.
Unpacking and Inspection
These in-ceiling loudspeakers are packaged
extremely well to make sure no damage occurs
during shipping. Carefully open the box and
remove the speakers. Inspect them
immediately for any kind of damage. The
speakers should have left our warehouse in
perfect condition so any damage must be
reported to your dealer or to TruAudio right
away. Please contact us immediately at
1.888.858.1555
All service to these products MUST be done by
TruAudio or a TruAudio Authorized repair
center. If you try to do any kind of repair, This
will void the warranty!
Choosing the Speaker Location
Before you install your speakers you should
take careful consideration their location. Make
sure to note location of lighting fixtures,
electrical, plumbing and any other obstructions.
If the house was pre-wired at construction time,
make sure you know where the speaker cable
is located in the wall or ceiling.
Wall Placement: When placing your speakers
into the wall, if possible, they should be
mounted facing toward the listening area.
Take in consideration where the furniture is
located when finalizing where the speaker will
be installed. Remember that with this type of
“built-in” architectural speaker, once the hole is
cut for the speaker installation, it is very costly
to move the location.
Preparation before Speaker Installation
If your home was pre-wired for speakers at
construction time, you might have used
TruAudio rough-in kits (RC series) prior to
drywall at each speaker location. (There should
also be speaker cable at this location). After
the drywall is installed and the hole is cut, the
speaker is then easily installed. Once the hole
is cut in the drywall, the pre-wired speaker
cable should be somewhere in the wall/ ceiling
near the hole. If you did use rough-in speaker
rings, move on to “Speaker Installation”.
If the speaker hole has not been cut from the
drywall please read the following instructions:
If the house is at the point of actual “Speaker
installation”, speaker cable should already be
run to each speaker location even if the hole is
not cut.
Find the location to where the speaker wire
